MasterForce 15A Jobsite Table Saw Manual do Operador descarregar pdf (Página 22)

Page 21

ASSEMBLY

FIG. 29

FIG. 30

Increase the length of the saw table by using

the extension table.

1. Set the rip fence to 13-3/4” (35 cm).

2. Push the extension-table locking lever

toward the back to unlock the lever.

3. Slide the extension table to the desired

width.

NOTICE: Use the scale on the extension rail

when a specic width is desired.

4. Once the extension table is set to the

desired width, re lock the lever by pulling

the lever forward.

ALIGNING THE BLADE TO THE

MITER GAUGE GROOVE

(FIG. 29-30)

The blade must be

square so that the wood does not bind,

resulting in kickback. Failure to do so

could result in serious personal injury.

Do not loosen any screws for this

adjustment until you have checked with

a square and made test cuts to be sure

adjustments are necessary. When the

screws are loosened, these items must be

reset.

1. Unplug the saw.

2. Turn the height-adjusting handle to

raise the blade all the way.

3. Place a mark beside one of the blade

teeth at the front of the blade. Place

the body of a combination square

against the miter gauge groove, and

measure the distance from the blade

tooth to the right miter gauge groove,

as shown in Fig. 29.

4. Turn the blade so that the marked tooth

is at the back.

5. Move the combination square to the

rear, and measure the distance from the

blade tooth to the right miter gauge

groove again. If the distances are the

same, the blade and the miter gauge

groove are parallel.

If the distances are different:

1. Unplug the saw. Locate the adjusting

mechanism.

NOTICE: The adjusting bolts are located

under the saw table at the back of the saw.

2. Loosen the adjusting bolts (1) and (2)

using the 3/16” (5 mm) hex key (included)

3. Turn the adjusting eccentric bolt (3)

and (4) left or right with the 15/64”

(6 mm) hex key (included) until the blade

is square.

4. Securely retighten the adjusting bolts (1)

and (2).

WARNING:

3 1 2 4

Right Miter

Gauge Groove

Combination

square

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comentários a estes Manuais

Sem comentários