MasterForce 15A Jobsite Table Saw Manual do Operador descarregar pdf (Página 17)

Page 16

ASSEMBLY

FIG. 14

FIG. 16

FIG. 17

INSTALLING THE

ANTI-KICKBACK PAWLS AND

BLADE GUARD ASSEMBLY

(FIG. 14-17)

NOTICE: The anti-kickback pawls should

only be installed for through cuts.

1. Unplug the saw.

2. Raise the saw blade to its highest

position. (See CHANGING BLADE

DEPTH.)

3. Place spreader/riving knife in the “up”

position (see instructions on page 15 and

Fig. 10).

To install the anti-kickback pawls:

1. Unplug the saw.

FIG. 15

2. Locate the anti-kickback pawls in the

storage compartment on the right side of

the table saw housing (Fig. 14).

3. Holding the anti-kickback pawls lever

with both hands, pivot the left lever

forward to unlock the pawls.

4. Align the slot in the pawls over the rear

hole in the spreader/riving knife.

5. Push the pawls down to snap them into

the slot and then pivot the left lever

backward.

To install the blade guard:

1. Unplug the saw.

2. Lift each guard barrier to its “up”

locked position: Note that the “up”

position is not the same for each guard

barrier.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Sem comentários

MasterForce 15A Jobsite Table Saw Manual do Operador Página 17