MasterForce 15A Jobsite Table Saw Manual do Operador descarregar pdf (Página 20)

Page 19

ASSEMBLY

FIG. 23

FIG. 24

FIG. 25

ADJUSTING THE BEVEL

INDICATOR (FIG. 23)

If the bevel indicator is not at 0° when the

saw blade is at 90º, adjust the indicator by

loosening the screw with the 5/32” (4 mm)

hex key (included) and setting it to 0º on the

bevel scale. Retighten the screw.

CHECKING THE ALIGNMENT

OF THE RIP FENCE TO

THE BLADE (FIG. 24)

1. Unplug the saw.

2. Remove the blade guard assembly.

3. Raise the locking lever to allow the rip

fence to be moved.

4. Place the framing square beside the

blade, and move the rip fence up to the

square. Note the measurement on the

rip scale.

5. Move the fence back, and rotate the

framing square 180º to check the other

side.

6. If the two measurements are not the

same, loosen the two screws on the

fence using a Phillips screwdriver (not

included), and then align it.

7. Retighten the two screws.

8. Make two or three test cuts using scrap

wood. If the cuts are not true, repeat the

process.

SETTING THE RIP FENCE SCALE

INDICATOR TO THE

BLADE (FIG. 25)

Begin with the blade at 0° angle (straight

up).

1. Unplug the saw.

2. Loosen the rip fence by lifting the

locking lever.

3. Place the rip fence on the saw table so

that it lightly touches the right side of

the saw blade. Lock the rip fence in place.

4. Loosen the screw using a Phillips

screwdriver (not included) and adjust the

indicator so that the red line is located

over the “0” line on the front rail of the

right-hand rip scale. Retighten the screw.

45° Stop Screw

90° Stop Screw

Bevel indicator

Rip fence

Blade

Screws

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comentários a estes Manuais

Sem comentários