MasterForce 15A Jobsite Table Saw Manual do Operador descarregar pdf (Página 15)

Page 14

ASSEMBLY

FIG. 10

FIG. 11

FIG. 12

SPREADER/RIVING KNIFE

POSITIONS (FIG. 10-11)

This saw is shipped with the spreader/riving

knife placed in the non-through cutting or

“down” position (riving knife position).

NOTICE: The spreader/riving knife must be

placed in the through-cutting or “up”

position (spreader position) for all other

cutting operations.

To place the spreader/riving knife in the

spreader position (“up” position) for all

through-cutting:

1. Unplug the saw.

2. Remove the throat plate by placing your

index nger in the hole and lifting the

front end, then pull the throat plate out

toward the front of the saw (Fig. 9).

3. Raise the saw blade as high as it will go

by turning the height-adjusting handle

clockwise and set the blade

perpendicular to the table.

4. Unlock the release lever by pivoting

it to the vertical position (see Fig. 10).

5. Pull the riving knife toward the release

lever to disengage it from the slots.

6. Grasp the spreader, and pull it up until

the internal slots engage and the

spreader is above the saw blade.

7. Lock the release lever by pushing it

to the horizontal position (Fig. 11).

8. Reinstall the throat plate.

NOTICE: When raising the spreader, exert

a small amount of force from the left side.

To place the spreader/riving knife in the

riving knife position (“down” position) for

all non-through cutting:

1. Unplug the saw.

2. Remove the throat plate by placing

your index nger in the hole and lifting

the front end, then pull the throat plate

out toward the front of the saw (Fig. 9).

3. Raise the saw blade as high as it will go

by turning the height-adjusting handle

clockwise and set the blade

perpendicular to the table.

4. Unlock the release lever by pivoting

it to the vertical position (see Fig. 12).

5. Pull the riving knife toward the release

lever to disengage it from the slots.

Release lever

(UN-Locked)

IN “UP” POSITION FOR

THROUGH CUTTING

Release lever

(Locked)

IN “DOWN” POSITION FOR

NON-THROUGH CUTTING

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comentários a estes Manuais

Sem comentários