MasterForce 241-0440 Manual do Operador descarregar pdf (Página 11)

Page 10

OPERATION

WARNING:

Be sure that the blade is

properly seated on the pulleys before starting

the cut.

To remove the blade, follow the installation

procedure in reverse.

WARNING:

The blade may kick up

as you released the blade tightening lever.

Do not face to the blade or position the blade

toward your body. Keep distance with it.

TYPICAL APPLICATION (FIG.6)

FIG. 6

1. Keep the blade off the workpiece until the

motor has reached the selected speed.

2. Start cutting on a surface where the

greatest number of teeth will be in contact

with the workpiece at one time (Fig 6).

3. Place the work steady rest against the

workpiece and lower the moving saw

blade into the cut.

4. Do not bear down while cutting. The

weight of the tool will supply adequate

pressure for the fastest cutting.

5. When completing a cut, hold the tool rmly

so it will not fall against the work-piece.

3

1

1. Blade

2. Bearing

3. Upper holder

4. Lower holder

4

2

FIG. 4

3

1

2

1. Upper holder

2. Lower holder

3. Wheel

FIG. 5

1. Detach the battery pack from the saw.

2. Detach the side handle.

3. Turn the blade tightening lever counter

clockwise 180°.

4. Making sure that the teeth on the left

side of the tool point towards the rear of

the tool.

5. Position the blade around the wheel and

insert the other side of the blade into

upper holder and the lower holder until

the blade back contact the bottom the

upper and lower holder.

6. Hold the blade in place and turn the blade

tightening lever counter-clockwise 180°,

this places proper tension on the blade.

7. Start and stop the saw two or three time

to make sure the blade runs properly on

the wheel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários