MasterForce 241-0440 Manual do Operador descarregar pdf (Página 14)

TYPICAL APPLICATION (Fig.7)

Keep the blade off the workpiece

until the motor has reached the

selected speed.

2. Start cutting on a surface where

the greatest number of teeth will

be in contact with the workpiece at

one time (Fig 7).

3. Place the work steady rest against

the workpiece and lower the moving saw blade into the cut.

4. Do not bear down while cutting. The weight of the tool will supply

adequate pressure for the fastest cutting.

5. When completing a cut, hold the tool ﬁrmly so it will not fall against the

work-piece.

MAINTENANCE

WARNING! Always wear safety goggles or safety glasses with side

shields during power tool operations, or when blowing dust. If operation is

dusty, also wear a dust mask.

It has been found that electric tools are subject to accelerated wear and

possible premature failure when they are used to work on ﬁber glass boats

and sports cars, wallboard, spackling compounds or plaster. The chips and

grindings from these materials are highly abrasive to electrical tool parts, such

as bearings, brushes, commutators, etc. Consequently, it is not recommended

that this tool be used for extended work on any ﬁberglass material, wallboard,

spackling compound or plaster. During any use on these materials, it is

extremely important that the tool is cleaned frequently by blowing with an

air jet.

WARNING! Do not at any time let brake ﬂuid, gasoline, petroleum-based

products, penetrating oils, etc. come in contact with plastic parts. Chemicals

can damage, weaken or destroy plastic, which may result in serious personal

injury.

Periodic maintenance allows for long life and trouble-free operation. A

cleaning and maintenance schedule should be maintained. As a common

preventive maintenance practice, follow these recommended steps:

When work has been completed, clean the tool to allow smooth functioning

Fig. 7

CORRECT

INCORRECT

1 2 ... 9 10 11 12 13 14 15 16

Sem comentários

MasterForce 241-0440 Manual do Operador Página 14